The commission process

Nothing is cut until you have seen it drawn.

Seven steps from a first message to a piece set in place. Each one ends with something you can hold: a measurement, a drawing, a sample, a board set aside for you.

Macro view of precise dovetail and mortise-and-tenon joinery in oak and walnut

01 — Seven steps

From a message to a piece in place.

  1. First conversation

    You send the room, the use, a rough size and any photos or references. A budget range helps more than people expect: it decides species and construction early, so the first drawing is realistic.

    You receive: Questions back, and an honest read on whether the piece suits the studio.

  2. Measure

    Dimensions, clearances, floor level, light and access, taken in person or from your plans. Doors, stairs and elevators are measured too, because a table has to get in.

    You receive: Confirmed dimensions for the drawing.

  3. Drawing & specification

    A scaled drawing of the piece in your room and a written spec: species, joinery, edge profile, finish and an approximate cost.

    You receive: Drawing and spec to approve or revise.

  4. Samples & selection

    Finish samples on the actual species, and the boards or slab chosen together, in person or from photos with measurements.

    You receive: An approved sample and the stock set aside.

  5. Making

    Milling, joinery, glue-ups, any resin pour, then flattening and shaping. This is the longest step and the quietest.

    You receive: Progress updates at the key stages.

  6. Finishing

    Sanded through the grits and finished in thin coats, then left to cure fully before it is wrapped.

    You receive: A final look before delivery.

  7. Delivery & setting in place

    Delivered, assembled where needed, levelled and set in place, with a date arranged with you.

    You receive: Care instructions written for your species and finish.

02 — Timing & payment

Straight answers, once they are confirmed.

Lead time depends on species, size, drying and the queue. It is stated in writing with every drawing.

Current lead time
[Lead time — to come]
Payment schedule
[Deposit & payment terms — to come]
Delivery area
Denver · [Wider area — to confirm]

03 — Before you write

What makes the first reply useful.

  1. 01

    Photos of the room

    Wide shots in daylight, plus the floor and anything the piece sits next to.

  2. 02

    Rough dimensions

    Even a tape-measure sketch. Exact numbers come in step two.

  3. 03

    References

    Pieces you love and pieces you don’t. Both are equally useful.

  4. 04

    Timing and a budget range

    An approximate range is fine. It keeps the first drawing honest.

Step one takes five minutes.

Rough sizes and an approximate budget are fine.

Start a commission